AquaSensor/en: Unterschied zwischen den Versionen

Zur Navigation springen Zur Suche springen
Keine Bearbeitungszusammenfassung
Markierungen: Mobile Bearbeitung Mobile Web-Bearbeitung
Keine Bearbeitungszusammenfassung
Markierungen: Mobile Bearbeitung Mobile Web-Bearbeitung
Zeile 12: Zeile 12:
A new series was needed. The board of management decided that the top-class dishwashers in this series should get an electronic controller, as already manufactured by [[Robert_Bosch_GmbH|Bosch]] and [[Siemens]]. The obsolete appliances still used a roller controller. Integrating a new electronic circuit board with the old roller controller did not offer any advantages however. The alternative was to use sensors to feed the signals to the electronic circuit board. The only problem was that they had not been developed as yet.<ref>BSH Corporate Archives, F-BSH-004, Stickel: Spülchronik, page 164.</ref>
A new series was needed. The board of management decided that the top-class dishwashers in this series should get an electronic controller, as already manufactured by [[Robert_Bosch_GmbH|Bosch]] and [[Siemens]]. The obsolete appliances still used a roller controller. Integrating a new electronic circuit board with the old roller controller did not offer any advantages however. The alternative was to use sensors to feed the signals to the electronic circuit board. The only problem was that they had not been developed as yet.<ref>BSH Corporate Archives, F-BSH-004, Stickel: Spülchronik, page 164.</ref>


This posed a tantalizing challenge for the present day head of the Dishwasher Care production division Michael Rosenbauer, who was an engineer at the time in Dillingen. He recognized the potential that lay in developing these sensors. His efforts resulted in the development of a turbidity sensor that detected the degree of dirt of the water. The development was called AquaSensor – based on the successful water damage protection solution [[AquaStop – reliable protection against water damage|AquaStop]].<ref>BSH Corporate Archives, F-BSH-004, Stickel: Spülchronik, page 164.</ref>
This posed a tantalizing challenge for the present day head of the Dishwasher Care production division Michael Rosenbauer, who was an engineer at the time in Dillingen. He recognized the potential that lay in developing these sensors. His efforts resulted in the development of a turbidity sensor that detected the degree of dirt of the water. The development was called AquaSensor – based on the successful water damage protection solution [[Special:MyLanguage/AquaStop_–_der_sichere_Schutz_vor_Wasserschäden|AquaStop]].<ref>BSH Corporate Archives, F-BSH-004, Stickel: Spülchronik, page 164.</ref>


The AquaSensor was integrated in the new GV630 dishwasher series and controlled the reusage or draining of the pre-rinse water by checking the cloudiness of the water. The AquaSensor thus helped save around 20 percent of the washing water.<ref>BSH Corporate Archives, F-BSH-004, Stickel: Spülchronik, page 164.</ref>
The AquaSensor was integrated in the new GV630 dishwasher series and controlled the reusage or draining of the pre-rinse water by checking the cloudiness of the water. The AquaSensor thus helped save around 20 percent of the washing water.<ref>BSH Corporate Archives, F-BSH-004, Stickel: Spülchronik, page 164.</ref>